Relative non-linearity: ≤ ±1.0 % F.S., normalized output signal 0 ... 10 V, stainless steel sensor, compact design, customer-specific versions possible from 20 pieces up
Please notice that there is a limit of 5 products for the product comparison.
Your latest selection was canceled.
×
Model | 8532 |
Measuring range |
0 … 500 N |
Direction of force | Compression |
Standardization | No |
Signal output | 2 mV/V |
Protection class | IP60 |
Overload protection | No |
Pull-plate | No |
Load introduction button | Yes |
Range of operating temperature | -20 ... +80 °C |
Specific characteristics |
|
This force measurement chain was developed for applications where a low cost solution is more important than achieving high levels of accuracy. The sensors strain gauge technology allows the measurement of static and dynamic forces. The load cell is also designed for applications that provide only little space due to its compact design. These properties, together with the sensors dust protection, make the measuring chain suitable for a wide range of applications, such as
The body of the sensor is a flat, cylindrical disk, into which a domed force application knob is integrated. It is important that the force is applied axially to the center of the sensor. The domed form, however, minimizes the effect of a force that is not exactly axial.
A full-bridge strain gauge is used as the measuring element inside the sensor, by means of which the force to be measured is converted into a proportional electrical voltage.
The in-line amplifier increases this voltage from 0 up to 10 V. The surface against which the sensor rests is important for the quality of the measurement. It should be ground. It must be sufficiently hard and thick and not deform under load
Example showing load cell fitted under pre-load with extreme overload protection
Talstr. 1-5
76593 Gernsbach
Germany
Fon: +49 7224645-0
Fax: +49 7224645-88
infoburster.com
www.burster.com
Wire
15.04. -
19.04.24 -
Düsseldorf,
40474,
Germany
The Battery Show
18.06. -
20.06.24 -
Stuttgart,
70269,
Deutschland
burster North America
Products Sales USA
burster Inc.
105 Laurel Creek Rd. SE
Suite: 10C Calhoun, GA. 30701, USA
Phone: +1-706-659-7472
salesburster.us
Products Sales USA
burster Inc.
304 State Route 303
44241 Streetsboro, Ohio, USA
Phone: +1-440-214-5333
salesburster.us
Sales Process Instruments USA
Physicom Corp
Scarborough, Ontario
Ontario M1E 4Y9, Canada
Phone: 416 7543168
Fax: 416 7542351
salesphysicomcorp.com
Sales Sensors & Process Instruments CANADA
A-Tech Instruments Ltd.
Scarborough, Ontario
Ontario M1E 4R5, Canada
Phone: 416 7547008
Fax: 416 7542351
salesa-tech.ca